Eigenschaften
- Waffentyp: AK-47
- Versandgewicht: 0,007kg
- Versandhöhe: 38mm
- Versandbreite: 51mm
- Versandlänge: 64mm
Artikeldetails

Preise inkl. MwSt., zzgl. Versand
Artikel-Nr.: 713000099
Herst.-Nr.: BT-BUF-003
Der Polymer-Puffer wird auf die Verschlussfeder montiert, um das Klopfen des Verschlusses, den fühlbaren Rückstoß und den allgemeinen Verschleiß zu reduzieren. Er bietet eine Dämpfung, die verhindert, dass der Verschluss mit dem Empfänger in Kontakt kommt, um den Verschleiß beider Komponenten zu verringern. Lässt sich einfach über das hintere Ende der Federbaugruppe installieren; keine dauerhaften Modifikationen am Gewehr erforderlich. Gut für mindestens 5.000 Schusszyklen.
Kostenloser Versand ab 299,00 €.
Lieferzeit ca. 14-21 Werktage.
SPECS: Polymer, schwarz. ½" (1,3 cm) lang, 15⁄16" (2,4 cm) breit, 1¼" (3,2 cm) hoch. Passt auf alle Modelle von AK-47, Mak-90, Galil und Valmet.
Poor Quality Polymer 27.03.2017
I used this buffer to Russian Saiga MK / AKM series 103. Is easy to install. Fits, but !!! Warranty is: "Good for at least 5,000 firing cycles". He deteriorated very rapidly. He does not resisted less than 300 cycles. The buffer has low quality.
I bought another from another company. It's all OK.
Causes problems on my M10 05.03.2017
This buffer caused problems on my build, increased felt recoil, and caused three short strokes out of 250 rounds.
On a properly built AK47 this is pointless snake oil. The bolt should never hit the rear trunion on a properly built AK, however if you add this buffer you take up the gap with this piece of plastic and the energy does transfer and you wind up with more felt recoil, in addition it has the potential to cause short stroking which I encountered.
Beim Laden dieses Inhalts ist ein Fehler aufgetreten. Bitte aktualisiere die Seite, um fortzufahren. Wenn das Problem weiterhin besteht, wende dich bitte an unseren Kundenservice.