Brownells Österreich - Einer der größten Lieferanten für Waffenteile, Büchsenmacherzubehör & Schießsportzubehör Österreich
853742008199 100040272
The Rise Armament AR-15 Anti-Walk Trigger Pins can give an extra level of security when installing your triggers. Pin diameter is .154”, with a torque spec on the screw of 11 inch-pounds maximum; 8 inch-pounds of torque are recommended. Note: The external width of AR receivers varies in the trigger/hammer pin area, depending on the manufacturer. If the pins are too long for your receiver, you may shorten the pins a small amount by carefully filing material evenly from both ends of the pins. However, this is not required. Longer pins will not affect the function or performance of the rifle.
27.9 27.9 1 EUR
Artikel-Nr.: 100040272
RISE ARMAMENT AR-15 ANTI-WALK TRIGGER PINS
Herstellerproduktnummer: 12005 853742008199 Die Anti-Walk-Abzugsstifte der Rise Armament AR-15 bieten ein zusätzliches Maß an Sicherheit bei der Installation Ihrer Abzüge. Der Stiftdurchmesser beträgt 0,154 Zoll, mit einem Drehmoment von maximal 11 Zoll-Pfund an der Schraube. 8 Zoll-Pfund Drehmoment werden empfohlen. Hinweis: Die Außenbreite der AR-Empfänger variiert je nach Hersteller im Bereich des Abzugs- / Hammerstifts. Wenn die Stifte für Ihren Empfänger zu lang sind, können Sie die Stifte geringfügig kürzen, indem Sie das Material vorsichtig gleichmäßig von beiden Enden der Stifte abfeilen. Dies ist jedoch nicht erforderlich. Längere Stifte beeinträchtigen weder die Funktion noch die Leistung des Gewehrs.
27.9 EUR 32 27,90 € *
Lieferzeit ca. 14-21 Werktage.
Mehr als 10 Stk. im Lager USA
Eigenschaften: Marke: AR-15

Eigenschaften

Marke: AR-15 Versandgewicht: 0,018kg Versandhöhe: 6mm Versandbreite: 76mm Versandlänge: 140mm




The Rise Armament AR-15 Anti-Walk Trigger Pins can give an extra level of security when installing your triggers. Pin diameter is .154”, with a torque spec on the screw of 11 inch-pounds maximum; 8 inch-pounds of torque are recommended. Note: The external width of AR receivers varies in the trigger/hammer pin area, depending on the manufacturer. If the pins are too long for your receiver, you may shorten the pins a small amount by carefully filing material evenly from both ends of the pins. However, this is not required. Longer pins will not affect the function or performance of the rifle.
Newsletter