Eigenschaften
- Waffentyp:
AR-15
- Versandgewicht: 0,113kg
- Versandhöhe: 15mm
- Versandbreite: 84mm
- Versandlänge: 168mm
- UPC: 811275020002
AR-15
Preise inkl. MwSt., zzgl. Versand
Artikel-Nr.: 100004436
Herst.-Nr.: CRT-AR
811275020002 Praktisches, zwei-in-eins Werkzeug entfernt schnell und einfach Kohlenstoffablagerungen aus kritischen Bereichen des Verschlusses und Trägers, um eine ordnungsgemäße Funktion des Verschlusses und zuverlässiges Zyklen zu gewährleisten. Schabe Kohlenstoff vom Träger mit dem Reibewerkzeug-Ende des Werkzeugs, reinige dann den Verschluss mit dem anderen Ende. Das einzigartige, drehbankähnliche Design passt sich jedem Verschlussradius an und sorgt so für ein universelles Werkzeug für jeden AR-Verschluss. Hergestellt aus gehärtetem Kohlenstoffstahl, verzinkt für Korrosionsbeständigkeit. Ein ideales Werkzeug für die Schießstandtasche, das Feld-Rüstzeug oder die „Notwendigkeiten“-Tasche.Lieferzeit ca. 14-21 Werktage.
Preise inkl. MwSt., zzgl. Versand
Das AR-15 CRT-15 CARBON REMOVAL TOOL und das CRT-AR CARBON REMOVAL TOOL von MAGNA-MATIC CORPORATION sind praktische, zwei-in-eins Werkzeuge, die Kohlenstoffablagerungen schnell und einfach aus den kritischen Bereichen des Bolzens und des Trägers entfernen. So wird die ordnungsgemäße Funktion des Bolzens und ein zuverlässiger Betrieb sichergestellt.
Ein ideales Werkzeug für deine Range-Tasche, das Feldarmorer-Kit oder die "Notwendigkeiten"-Tasche.
AR-15
It works as advertised. 12.08.2013
It works exactly as advertised. It makes life easier and cleaning quicker.
Works, good addition to the box 18.04.2013
So here's the deal. Its a great tool, BUT you have to understand its not magic. Just like any cleaning tool, it comes down to the time you put in. I find that this is a GREAT tool for getting the 98% of the carbon off the tail of the bolt and inside the carrier. My BCM carrier is machined well at the back of the chamber where the bolt and gas rings seat. DEPENDING on how clean the machining is on your BCG will determine how well this tool works. If a tool and carrier is in spec, you will be fine. A lower end carrier that may not be machined well could have uneven surfaces that carbon will sit in and this tool will not get it.
Beim Laden dieses Inhalts ist ein Fehler aufgetreten. Bitte aktualisiere die Seite, um fortzufahren. Wenn das Problem weiterhin besteht, wende dich bitte an unseren Kundenservice.