This mount comes standard with a bevel on both sides making it ambidextrous. EGW recommends measuring the hole spacing in your receiver to confirm it matches with the dimensions they have published. Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Their one-piece scope mounts are the obvious choice for hunters and tactical shooters alike. They machine these in their shop using one of their machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability. Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is sold separately). They recommend: 0 MOA - if shooting 0-500 yards 20 MOA - if shooting 500-1000 yards When zeroing your rifle with a 20 MOA mount, they recommend zeroing at 200 yards. The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
Die perfekte Montage für dein Browning T-Bolt!
Die BROWNING T-BOLT PICATINNY SCOPE MOUNT von EGW ist die ideale Wahl für alle, die Flexibilität und Qualität schätzen. Diese Montage kommt standardmäßig mit einer Fase an beiden Seiten, was sie beidhändig verwendbar macht.
Produktbeschreibung
EGW empfiehlt, die Lochabstände in deinem Receiver zu messen, um sicherzustellen, dass sie mit den veröffentlichten Abmessungen übereinstimmen. Die Picatinny-Cross-Slots verlaufen über die gesamte Länge der Schiene, was dir beim Anbringen von Zielfernrohrringen und anderen Zubehörteilen viel Spielraum gibt. Der Kanal in der Mitte reduziert die Gesamtmasse der Montage und wird in vielen Fällen die Nutzung der werkseitigen Kimme und Korn nicht behindern.
Die einteiligen Zielfernrohrmontagen sind die offensichtliche Wahl für Jäger und taktische Schützen gleichermaßen. EGW fertigt diese in ihrer Werkstatt mit einem ihrer Bearbeitungszentren. Nach der Bearbeitung werden die Montagen getrommelt, sandgestrahlt und mit einer Typ II-Anodisierung versehen, um eine langanhaltende Haltbarkeit zu gewährleisten.
Installation
- EGW empfiehlt ein Drehmoment von 20 Inch-Pounds und einen Tropfen blauen Loctite (Loctite ist separat erhältlich).
- Sie empfehlen:
- 0 MOA - wenn du auf 0-500 Yards schießt
- 20 MOA - wenn du auf 500-1000 Yards schießt
Beim Zielen deines Gewehrs mit einer 20 MOA Montage empfehlen sie, auf 200 Yards zu nullen. Die gesamte Montage und das Zubehör (von den Montageschrauben und dem Schlüssel bis hin zur Verpackung) werden in den USA hergestellt.