Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Die perfekte Montage für dein Trijicon RMR Rotpunktvisier!
Die CZ SHADOW 2 TRIJICON RMR SIGHT MOUNT von EGW ist die ideale Lösung, um dein Trijicon RMR oder Holosun HS507C auf deiner Waffe zu montieren. Hier sind die Details:
Produktbeschreibung
- Material: 7075 Aluminium
- Beschichtung: Matt Schwarz Hardcoat
- Gesamtlänge: 1.780"
- Gesamtbreite: 1.1"
- Montagehardware: (2) 6-32 Flachkopfschrauben, (1) 6-32 X 3/16 Set-Schraube
Kompatibilität:
- Passt für: Baby Desert Eagle (nach 2006), EAA Witness Elite Match
- Passt nicht für: Rock Island 1911s
Um dein Trijicon RMR Rotpunktvisier zu montieren, entferne einfach die Kimme deiner Waffe und ersetze sie durch unsere Montage. Es sind keine Änderungen an deiner Waffe erforderlich. Du kannst die Montage jederzeit wieder abnehmen und deine Kimme zurücksetzen. Die Montagehardware ist im Lieferumfang enthalten.
Installationsanleitung
- Entferne die Kimme*
- Installiere die EGW Sight Mount in der Schwalbenschwanzführung
- Ziehe die Set-Schraube fest (falls zutreffend)
- Lege das Rotpunktvisier auf die EGW Sight Mount (ein kleines Stück Papier zwischen dem Rotpunktvisier und der Montage erleichtert die Entfernung und schützt das Rotpunktvisier vor Loctite).
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf
- Ziehe die Montageschrauben auf 15 in/lbs fest
Hinweis: Die mit dieser Montage gelieferten Schrauben benötigen einen 5/64'' Innensechskantschlüssel zur Installation.