EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not work with USP Compact, USP Expert, USP Elite, VP9, VP40, P30, P30L, P30SK, HK45, or HK45C.
Die perfekte Lösung für deine H&K USP!
Der H&K USP VORTEX VIPER/VENOM SIGHT MOUNT von EGW ist die ideale Ergänzung für deine Waffe. Mit diesem Montagesystem kannst du problemlos dein Vortex Viper oder Venom Red Dot Sight anbringen.
Produktbeschreibung
Die EGW Red Dot Sights sind so konzipiert, dass sie von links nach rechts installiert werden (mit dem Lauf nach vorne gerichtet). Die Schwalbenschwanznut hat eine progressive Verjüngung, die die Installation erleichtert.
- Entferne die hintere Visierung deiner Waffe.
- Installiere die EGW Sight Mount in der Schwalbenschwanznut.
- Ziehe die Set-Schraube fest (falls zutreffend).
- Platziere das Red Dot Sight auf der EGW Sight Mount (ein kleines Stück Papier zwischen dem Red Dot Sight und der Montage erleichtert die Entfernung und hält Loctite vom Red Dot Sight fern).
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf.
- Ziehe die Montageschrauben mit 15 in/lbs fest.
Mitgeliefertes Zubehör
- 2 Button Head Cap Screws - für Vortex Viper und Venom Sights
- 2 Flat Head Cap Screws - für Burris FastFire und Docter Sights
Die Schrauben, die mit diesem Mount geliefert werden, benötigen einen 5/64'' Inbusschlüssel für die Installation.
Bitte beachte: Änderungen an deiner Feuerwaffe können die Garantie des Herstellers ungültig machen. Dieses Produkt sollte von einem qualifizierten Büchsenmacher installiert und überprüft werden. Es wird keine Haftung für Schäden oder Verletzungen übernommen, die aus unsachgemäßer Installation oder Verwendung dieses Produkts resultieren.
Dieser Mount ist nicht mit USP Compact, USP Expert, USP Elite, VP9, VP40, P30, P30L, P30SK, HK45 oder HK45C kompatibel.