Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Optimiere deine Zielgenauigkeit mit dem H&K USP TRIJICON RMR SIGHT MOUNT!
Der H&K USP TRIJICON RMR SIGHT MOUNT von EGW ist die perfekte Lösung, um dein Trijicon RMR Red Dot Sight sicher und stabil zu montieren. Mit hochwertigem Material und durchdachtem Design bietet dieser Mount alles, was du benötigst.
Produktbeschreibung
- Material: 7075 Aluminium
- Beschichtung: Matte Black Hardcoat
- Gesamtlänge: 1.780"
- Gesamtbreite: 1.1"
- Befestigungselemente: (2) 6-32 Flat Head Schrauben, (1) 6-32 X 3/16 Set Schraube
- Red Dot Kompatibilität: Trijicon RMR, Holosun HS507C
Kompatibilität
Dieser Mount passt zu:
- Baby Desert Eagle (Post 2006)
- EAA Witness Elite Match
Dieser Mount passt nicht zu:
Installation
So installierst du den Mount:
- Entferne die hintere Visierung deines Gewehrs.
- Installiere den EGW Sight Mount in der Dovetail.
- Ziehe die Set Schraube (falls zutreffend) fest.
- Platziere das Red Dot Sight auf dem EGW Sight Mount. (Ein kleines Stück Papier zwischen dem Red Dot Sight und dem Sight Mount erleichtert die Entfernung und hält Loctite vom Red Dot Sight fern.)
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf.
- Ziehe die Montageschrauben mit 15in/lbs an.
Die mitgelieferten Schrauben benötigen einen 5/64'' Inbusschlüssel für die Installation.