EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount fits: Kimber 1911 (adjustable rear sights for windage and elevation) Ruger SR1911 (adjustable rear sights for windage and elevation)
Optimiere dein Kimber 1911 mit dem EGW Adjustable Sight Mount!
Der KIMBER 1911 Adjustable Sight Vortex Viper/Venom Sight Mount von EGW ermöglicht dir eine einfache Montage deiner Vortex Viper oder Venom Red Dot Sights. Mit diesem Mount kannst du das Beste aus deinem Kimber 1911 herausholen!
Produktbeschreibung
Die EGW Red Dot Sights sind so konzipiert, dass sie von links nach rechts installiert werden (mit dem Mündungsende nach vorne). Der Dovetail hat eine progressive Taper, die die Installation erleichtert. Entferne einfach die Kimme deines Gewehrs und ersetze sie durch den EGW Mount, um deine Vortex Viper/Venom, Burris FastFire oder Docter Red-Dot-Sicht zu montieren. Du kannst den Mount jederzeit abnehmen und deine Kimme wieder anbringen.
Installationsanleitung
- Entferne die Kimme*
- Installiere den EGW Sight Mount im Dovetail
- Ziehe die Set-Schraube fest (falls zutreffend)
- Platziere die Red Dot Sight auf dem EGW Sight Mount (ein kleines Stück Papier zwischen der Red Dot Sight und dem Mount erleichtert die Entfernung und hält Loctite von der Red Dot Sight fern).
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf
- Ziehe die Montageschrauben mit 15 in/lbs fest
Mitgeliefertes Zubehör
- 2 Button Head Cap Screws - für Vortex Viper und Venom Sights
- 2 Flat Head Cap Screws - für Burris FastFire und Docter Sights
Die mit diesem Mount gelieferten Schrauben erfordern einen 5/64'' Inbusschlüssel für die Installation. Dieser Mount passt auf:
- Kimber 1911 (verstellbare Kimme für Windage und Elevation)
- Ruger SR1911 (verstellbare Kimme für Windage und Elevation)
*Hinweis: Bitte beachte die Installationsanleitung sorgfältig, um die besten Ergebnisse zu erzielen.