Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Verbessere deine Zielgenauigkeit mit dem KIMBER FIXED REAR SIGHT TRIJICON RMR SIGHT MOUNT!
Der KIMBER FIXED REAR SIGHT TRIJICON RMR SIGHT MOUNT von EGW ist die perfekte Lösung, um deine Trijicon RMR Rotpunktvisier sicher und stabil zu montieren. Hier sind die Details:
Produktbeschreibung
- Material: 7075 Aluminium
- Beschichtung: Matte Black Hardcoat
- Gesamtlänge: 1.780"
- Gesamtbreite: 1.1"
- Montagehardware: (2) 6-32 Flat Head Schrauben, (1) 6-32 X 3/16 Set-Schraube
- Rotpunkt-Kompatibilität: Trijicon RMR, Holosun HS507C
Kompatibilität
Dieser Mount passt auf:
- Baby Desert Eagle (nach 2006)
- EAA Witness Elite Match
Dieser Mount passt nicht auf:
Einfacher Austausch
Du kannst einfach das hintere Visier deines Gewehrs entfernen und durch unseren Mount ersetzen, um dein Trijicon RMR Rotpunktvisier zu montieren. Es sind keine Änderungen erforderlich. Du kannst unseren Mount jederzeit abnehmen und dein hinteres Visier wieder einsetzen. Montagehardware ist im Lieferumfang enthalten.
Installationsanleitung
- Entferne das hintere Visier*
- Installiere den EGW Sight Mount im Dovetail
- Ziehe die Set-Schraube (falls zutreffend) fest
- Platziere das Rotpunktvisier auf dem EGW Sight Mount (ein kleines Stück Papier zwischen dem Rotpunktvisier und dem Mount erleichtert die Entfernung und schützt das Rotpunktvisier vor Loctite).
- Trage blauen Loctite auf die bereitgestellten Montageschrauben auf
- Ziehe die Montageschrauben mit 15 in/lbs an
Hinweis: Die im Lieferumfang enthaltenen Schrauben erfordern einen 5/64'' Innensechskantschlüssel für die Installation.