EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not fit: Kimber Micro Kimber Micro 9
Robuste Montage für deine Vortex Viper/Venom
Die KIMBER FIXED SIGHT VORTEX VIPER/VENOM SIGHT MOUNT von EGW bietet eine zuverlässige Lösung, um deine Vortex Viper oder Venom Optik sicher an deiner Kimber 1911 zu befestigen.
Produktbeschreibung
Die EGW Red Dot Sights sind so konzipiert, dass sie von links nach rechts (mit dem Mündungsende nach vorne) installiert werden. Die Schwalbenschwanzführung hat eine progressive Verjüngung, die eine einfachere Installation ermöglicht.
- Entferne das hintere Visier deiner Waffe
- Installiere die EGW Sight Mount in der Schwalbenschwanzführung
- Ziehe die Set-Schraube (falls zutreffend) fest
- Platziere das Red Dot Sight auf der EGW Sight Mount (ein kleines Stück Papier zwischen dem Red Dot Sight und der Montage erleichtert die Entfernung und verhindert, dass Loctite auf das Red Dot Sight gelangt)
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf
- Ziehe die Montageschrauben mit 15in/lbs an
Mitgeliefertes Zubehör:
- 2 Button Head Cap Screws - Für Vortex Viper und Venom Sights
- 2 Flat Head Cap Screws - Für Burris FastFire und Docter Sights
Die Schrauben, die mit dieser Montage geliefert werden, benötigen einen 5/64'' Inbusschlüssel für die Installation.
Hinweis: Änderungen an deiner Feuerwaffe können die Garantie des Herstellers ungültig machen. Dieses Produkt sollte von einem qualifizierten Büchsenmacher installiert und überprüft werden. Es wird keine Haftung für Schäden oder Verletzungen übernommen, die aus unsachgemäßer Installation oder Nutzung dieses Produkts resultieren.
Diese Montage passt nicht:
- Kimber Micro
- Kimber Micro 9