Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Die perfekte Lösung für deine Trijicon RMR Montage!
Die LPA Trijicon RMR Sight Mount von EGW bietet dir eine robuste und zuverlässige Möglichkeit, dein Trijicon RMR Rotpunktvisier zu montieren. Sie ist ideal für den Einsatz auf verschiedenen Handfeuerwaffen, darunter:
- Baby Desert Eagle (Post 2006)
- EAA Witness Elite Match
Diese Montage passt jedoch nicht auf Rock Island 1911s. Hier sind einige technische Details:
Produktdetails
- Material: 7075 Aluminium
- Beschichtung: Matte Black Hardcoat
- Gesamtlänge: 1.780"
- Gesamtbreite: 1.1"
- Montagematerial: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
- Kompatibilität: Trijicon RMR, Holosun HS507C
Um dein Trijicon RMR Rotpunktvisier zu montieren, entferne einfach die hintere Visierung deiner Waffe und ersetze sie durch unsere Montage. Es sind keine Änderungen an deiner Waffe erforderlich, und du kannst die Montage jederzeit wieder abnehmen und die hintere Visierung wieder anbringen.
Installationsanleitung
- Die hintere Visierung entfernen*
- Die EGW Sight Mount in die Schwalbenschwanzführung einsetzen
- Set-Schraube anziehen (falls zutreffend)
- Das Rotpunktvisier auf die EGW Sight Mount setzen (ein kleines Stück Papier zwischen dem Rotpunktvisier und der Montage erleichtert die Demontage und hält Loctite vom Rotpunktvisier fern).
- Blaue Loctite auf die mitgelieferten Montageschrauben auftragen
- Montageschrauben mit 15 in/lbs anziehen
Hinweis: Die mit dieser Montage gelieferten Schrauben benötigen einen 5/64'' Inbusschlüssel für die Installation.