Eigenschaften
- Versandgewicht: 0,045kg
- Versandhöhe: 13mm
- Versandbreite: 76mm
- Versandlänge: 254mm
- UPC: 050806023253
Preise inkl. MwSt., zzgl. Versand
Artikel-Nr.: 587036968
Herst.-Nr.: 36968
050806023253 Ursprünglich für Metallarbeiter und Mechaniker entwickelt, um festsitzende Bolzen zu entfernen, beißen diese schweren Extraktoren in das Metall für zusätzlichen Halt, sodass du die nötige Kraft aufbringen kannst, um einen Choke zu entfernen, der sich mit normalen Werkzeugen nicht bewegen lässt. Erhältlich für 12 und 20 Gauge. Vollständige Anleitungen sind enthalten. Vorsicht: Mündungsbeschädigungen können auftreten, wenn das Werkzeug falsch verwendet wird.Nachbestellt, Lieferzeit ca. 4-12 Wochen aus dem Lager USA.
Preise inkl. MwSt., zzgl. Versand
Das STUCK CHOKE REMOVAL TOOL von BROWNELLS ist das perfekte Werkzeug, um festsitzende Chokes zu entfernen. Ursprünglich für Metallarbeiter und Mechaniker entwickelt, um festsitzende Bolzen zu lösen, beißt dieser robuste Extraktor in das Metall und sorgt so für zusätzlichen Halt. Damit kannst du die nötige Kraft aufbringen, um einen Choke zu entfernen, der sich mit herkömmlichen Werkzeugen nicht bewegen lässt.
Werkzeugstahl, schwarze Oxidbeschichtung.
Didn't work 12.08.2014
I tried to remove a stuck choke tube from a Bennelli shotgun with no luck at all. I had previously talked with a Brownell's consultant and was told to follow the written instructions that came with the tool. I did that to the letter. The cutting edges of the tool were softer than the choke tube metal and merely broke away as I tried to twist the tool.
I finally had to try another method of removal which I found on Youtube. I used JB Weld to glue in a deep well socket that was about 1/8 of an inch smaller in diameter than the choke tube. After letting it set up for 24 hours I used a ratchet to remove the socket which bonded to the choke tube.
I would return the tool to Brownells except that postage would cost as much as the tool.
Worked well 02.04.2014
I had an inventor DS choke tube stuck in an A5 thats about a year old. Tried everything to get the choke out to the point where wrenches wore the notches on the tube.
I bought this tool as a hail mary before relenting and going to a gunsmith. It took a couple tries and tapping the tool in harder, but with a crescent wrench and a couple sharp raps with a hammer to the tool was finally able to get the tube out. No damage to barrel, choke was not any more messed than before, junking it though.
You might have drive the tool in a little harder than you think.
Good price shipping was good, fedex is always good.
Beim Laden dieses Inhalts ist ein Fehler aufgetreten. Bitte aktualisiere die Seite, um fortzufahren. Wenn das Problem weiterhin besteht, wende dich bitte an unseren Kundenservice.