Eigenschaften
- Versandgewicht: 0,027kg
- Versandhöhe: 25mm
- Versandbreite: 97mm
- Versandlänge: 97mm
- UPC: 854263007302
Nicht verfügbar.
Artikel-Nr.: 100025316
Herst.-Nr.: 100-138
Benachrichtigt werden, sobald verfügbar? Hier klicken 259.9 EURDas Apex Tactical Aluminium Action Enhancement Trigger Kit ist speziell entwickelt, um deinem S&W M&P 9mm/.40 einen sanfteren, konsistenteren und leichteren (5 bis 5-1/2 lb.) Abzug mit einem kürzeren Rücklauf als der Standardabzug zu verleihen.
Im Lieferumfang enthalten:
Das Kit passt auf alle S&W M&P Pistolen in 9mm und .40 S&W. Es ist jedoch nicht für die Modelle M&P45, M&P M2.0, M&P Shield oder .22 LR geeignet.
Obwohl das Apex Aluminium Action Enhancement Trigger Kit für M&P 9mm/.40 so konzipiert ist, dass es einfach eingebaut werden kann und normalerweise keine weitere Waffenbearbeitung erfordert, wird die Installation durch einen Waffenmeister oder Büchsenmacher empfohlen.
Trigger is nice but thatâs it! 12.11.2017
I installed this kit and the pistol would fire a round or two and then I would only get light primer strikes and no bang? I contacted Apex and they said to bend a bar in the lower but not to much as it is not heat treated and can break! Did that and still same results! Did it a few more times with no success so I sold the kit to someone else who wanted to try it out.
Sorry it didnât work out as it seemed like a good upgrade!
Great Trigger! 24.10.2017
I purchased this product from Brownells.com
Pros
Hard anodized aluminum trigger compared to the stock trigger is stiffer and does not cause sideways trigger movement causing accuracy to suffer.
Trigger pull was consistent 4.25 lb trigger pull (stock 5.75 lb).
Very Clean Break
Cons
On my gun I had to adjust the trigger bar adjustment to meet the sear. It is not difficult to do but you need feeler gauges to make sure that you don't over adjust. If you do the pistol will become unsafe. When adjusting the trigger bar add .005 at a time from the original gap. Watch the Apex video on adjusting the trigger bar and your not comfortable doing it have a gun smith do it for you.
Tools Required:
1/8" Roll punch
Universal Bench Block
Light Hammer
Sight Vise or Brass Drift
If you don't already have the tools you can buy them but the cost might be more effective to have a gunsmith install unless you need it for other firearms.
Beim Laden dieses Inhalts ist ein Fehler aufgetreten. Bitte aktualisiere die Seite, um fortzufahren. Wenn das Problem weiterhin besteht, wende dich bitte an unseren Kundenservice.