Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Entdecke die perfekte Lösung für deine Trijicon RMR Montage!
Die S&W REVOLVER TRIJICON RMR SIGHT MOUNT von EGW ist die ideale Ergänzung für deine Waffe. Hier sind die Details:
- Material: 7075 Aluminium
- Beschichtung: Matte Black Hardcoat
- Gesamtlänge: 1.780"
- Gesamtbreite: 1.1"
- Befestigungsmaterial: (2) 6-32 Flachkopfschrauben, (1) 6-32 X 3/16 Set-Schraube
- Red Dot Passform: Trijicon RMR, Holosun HS507C
Diese Montage passt für:
- Baby Desert Eagle (Post 2006)
- EAA Witness Elite Match
Diese Montage passt nicht für:
Um dein Trijicon RMR Red Dot Sight zu montieren, entferne einfach die hintere Visierung deiner Waffe und ersetze sie durch unsere Montage. Es sind keine Änderungen erforderlich. Du kannst unsere Montage jederzeit wieder abnehmen und deine hintere Visierung ersetzen. Befestigungsmaterial ist im Lieferumfang enthalten.
Montageanleitung
- Entferne die hintere Visierung*
- Installiere die EGW Sight Mount im Dovetail
- Ziehe die Set-Schraube an (falls zutreffend)
- Setze das Red Dot Sight auf die EGW Sight Mount (ein kleines Stück Papier zwischen dem Red Dot Sight und der Montage erleichtert das Entfernen und hält Loctite vom Red Dot Sight fern.)
- Trage blauen Loctite auf die bereitgestellten Befestigungsschrauben auf
- Ziehe die Befestigungsschrauben auf 15 in/lbs an
2 Flachkopfschrauben - Bereitgestellt für Trijicon RMR. Die mit dieser Montage gelieferten Schrauben benötigen einen 5/64'' Inbusschlüssel zur Installation.