EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with the mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.
Optimale Montage für deine Vortex Viper/Venom auf Taurus G2/G3!
Die EGW Red Dot Sights sind so konzipiert, dass sie von links nach rechts installiert werden (mit dem Lauf nach vorne gerichtet). Der Schwalbenschwanz hat eine progressive Verjüngung, um die Installation zu erleichtern.
Einfach die hintere Visierung deines Gewehrs entfernen und durch die Montage ersetzen, um dein Vortex Viper/Venom, Burris FastFire oder Docter Red-Dot Sight zu montieren. Du kannst die Montage jederzeit abnehmen und deine hintere Visierung wieder anbringen.
Montageanleitung
- Entferne die hintere Visierung*
- Installiere die EGW Sight Mount im Schwalbenschwanz
- Ziehe die Set-Schraube an (falls zutreffend)
- Setze das Red Dot Sight auf die EGW Sight Mount (ein kleines Stück Papier zwischen dem Red Dot Sight und der Sight Mount erleichtert die Entfernung und hält Loctite vom Red Dot Sight fern.)
- Trage blauen Loctite auf die mitgelieferten Montageschrauben auf
- Drehmoment der Montageschrauben auf 15 in/lbs einstellen
Lieferumfang:
- 2 Button Head Cap Screws - Für Vortex Viper und Venom Sights
- 2 Flat Head Cap Screws - Für Burris FastFire und Docter Sights
Die mit dieser Montage gelieferten Schrauben erfordern einen 5/64'' Inbusschlüssel für die Installation.
Bitte beachte, dass Modifikationen an deinem Feuerwaffen die Herstellergarantie ungültig machen können. Dieses Produkt sollte von einem qualifizierten Büchsenmacher installiert und überprüft werden.
Es wird keine Haftung für Schäden oder Verletzungen übernommen, die aus unsachgemäßer Installation oder Verwendung dieses Produkts resultieren können.