Eigenschaften
- Modell:
29
,20
,17
,19
,22
,23
,24
,34
,35
,26
,27
,31
,32
,33
,18
- Waffentyp:
Glock
- Versandgewicht: 0,005kg
- Versandbreite: 83mm
- Versandlänge: 146mm
Preise inkl. MwSt., zzgl. Versand
Artikel-Nr.: 642102021
Herst.-Nr.: LS7924
Der extrem leichte Titan-Sicherheitsplunger reduziert die Masse für einen leichteren Abzugsweg. Die Titan-Nitrid-Beschichtung verringert die Reibung. Ein kleines Detail, das hilft, einen Glock®-Abzug zu optimieren. Enthält eine Wolff Sicherheitsplungerfeder.Nachbestellt, Lieferzeit ca. 4-12 Wochen aus dem Lager USA.
Preise inkl. MwSt., zzgl. Versand
Der extrem leichte Titanium Safety Plunger reduziert die Masse für einen leichteren Abzug. Mit einer Titanium-Nitrid-Beschichtung wird die Reibung minimiert. Dieses kleine Detail hilft dir, einen Glock®-Abzug zu perfektionieren.
Hol dir den TITANIUM SAFETY PLUNGER von LIGHTNING STRIKE und erlebe einen spürbar besseren Abzug!
29,
20,
17,
19,
22,
23,
24,
34,
35,
26,
27,
31,
32,
33,
18
Glock
Not suitable for self defense .. 12.04.2018
The lower cylinder started to scar and leave metal chips in my plunger hole after 100 rounds. Glock 17. Not suitable for a self defense or high use range gun. It simply is not reliable. Someone needs to hire a metallurgist and rework this entire thing. Helped smooth out trigger quite a bit when new. Used with six pound spring, and 3.5 lb trigger connector. Like tossing 20 dollars down the toilet. Went back to just polishing the glock saftey plunger.
Longevity issues 01.04.2015
I wish it lasted a little longer. I wore this sucker out with just over 3,000 rounds down the pipe. When I first installed the Ti plunger its operation was smooth and silky, but with over 3,000 rounds through my Gen4 G22 with the Ti Safety Plunger installed, it was beginning to feel gritty and showing signs of wear, most notable is scoring of the cylinder edge that contacts the extractor. I like this product, but I had to pull it out of my weapon when I found metal shavings inside the plunger hole, striker pin channel and on the extractor. I run my weapon pretty hard and never experienced a malfunction or FTE, but I cannot continue to use this plunger in it's current condition.
Hmmm.... I wonder if Brownells will replace it? Maybe I should give the sales team a call.
Beim Laden dieses Inhalts ist ein Fehler aufgetreten. Bitte aktualisiere die Seite, um fortzufahren. Wenn das Problem weiterhin besteht, wende dich bitte an unseren Kundenservice.