FHD FLASH HIDERS These fit the plan B type mounts. This is an updated version that has larger wrench flats on the rear. Always use an alignment rod to ensure that the entire system is set up correctly. Make sure all surfaces are cleaned and the muzzle device has been torqued and Rockset to the barrel. Use on a Q can voids your warranty, be warned. Torque the muzzle device to approximately 30 ft lbs. Make sure the muzzle device is square against the shoulder. When setting the silencer on the muzzle device, ensure that the threads and tapers are clean. Torque the suppressor to 10 ft lbs. Ensure alignment. Enjoy. The nitride finish does lead to a tighter seal, with that said, it is extremely important to torque and rockset your muzzle device to the barrel properly. FEATURES: 17-4 PH H900 Atlas and Atlas XL Compatible Plan B Compatible Atlas XL Adapter No Overrun Black Nitride Finish (67 HRC Surface Hardness) Shims Not Included, if you would like to specifically time this, shims will be required. Note: your barrel may require a shim if the manufacturer did not put a thread relief on it.
Entdecke die FHD FLASH HIDERS für deine Waffe!
Die FHD FLASH HIDERS sind perfekt für die Plan B Montagen geeignet. Diese aktualisierte Version verfügt über größere Werkzeugflächen an der Rückseite. Achte darauf, immer eine Ausrichtungsstange zu verwenden, um sicherzustellen, dass das gesamte System korrekt eingerichtet ist.
Wichtige Hinweise:
- Alle Oberflächen müssen gereinigt sein.
- Das Mündungsgerät muss ordnungsgemäß angezogen und mit Rockset am Lauf befestigt werden.
- Die Verwendung an einem Q Can kann deine Garantie ungültig machen, sei gewarnt.
- Das Mündungsgerät sollte auf etwa 30 ft lbs angezogen werden.
- Stelle sicher, dass das Mündungsgerät rechtwinklig zur Schulter sitzt.
- Beim Anbringen des Schalldämpfers auf das Mündungsgerät, achte darauf, dass die Gewinde und Taper sauber sind.
- Der Schalldämpfer sollte auf 10 ft lbs angezogen werden. Achte auf die Ausrichtung.
Genieße die Vorteile! Die Nitride-Beschichtung sorgt für eine bessere Abdichtung. Es ist jedoch äußerst wichtig, dass du dein Mündungsgerät richtig am Lauf anziehst und mit Rockset fixierst.
Produkteigenschaften:
- 17-4 PH H900
- Kompatibel mit Atlas und Atlas XL
- Plan B kompatibel
- Atlas XL Adapter ohne Überlauf
- Schwarze Nitride-Oberfläche (67 HRC Oberflächenhärte)
- Shims sind nicht enthalten; wenn du dies speziell timen möchtest, werden Shims benötigt.
Hinweis: Dein Lauf benötigt möglicherweise einen Shim, wenn der Hersteller keinen Gewindeauslass vorgesehen hat.