FHD FLASH HIDERS These fit the plan B type mounts. This is an updated version that has larger wrench flats on the rear. Always use an alignment rod to ensure that the entire system is set up correctly. Make sure all surfaces are cleaned and the muzzle device has been torqued and Rockset to the barrel. Use on a Q can voids your warranty, be warned. Torque the muzzle device to approximately 30 ft lbs. Make sure the muzzle device is square against the shoulder. When setting the silencer on the muzzle device, ensure that the threads and tapers are clean. Torque the suppressor to 10 ft lbs. Ensure alignment. Enjoy. The nitride finish does lead to a tighter seal, with that said, it is extremely important to torque and rockset your muzzle device to the barrel properly. FEATURES: 17-4 PH H900 Atlas and Atlas XL Compatible Plan B Compatible Atlas XL Adapter No Overrun Black Nitride Finish (67 HRC Surface Hardness) Shims Not Included, if you would like to specifically time this, shims will be required. Note: your barrel may require a shim if the manufacturer did not put a thread relief on it.
Entdecke die FHD FLASH HIDERS für dein perfektes Setup!
Die FHD FLASH HIDERS sind die ideale Ergänzung für deine Plan B Montage. Diese aktualisierte Version verfügt über größere Schraubflächen an der Rückseite, was die Handhabung erleichtert. Achte darauf, immer einen Ausrichtungsstab zu verwenden, um sicherzustellen, dass das gesamte System korrekt eingerichtet ist.
Wichtige Hinweise:
- Reinige alle Oberflächen gründlich.
- Der Mündungsgerät muss mit dem Lauf torqued und mit Rockset fixiert werden.
- Die Verwendung an einem Q Can kann deine Garantie ungültig machen – sei gewarnt!
- Torque das Mündungsgerät auf ca. 30 ft lbs.
- Stelle sicher, dass das Mündungsgerät rechtwinklig zur Schulter steht.
- Beim Anbringen des Schalldämpfers auf das Mündungsgerät, achte darauf, dass die Gewinde und Taper sauber sind.
- Torque den Schalldämpfer auf 10 ft lbs und überprüfe die Ausrichtung.
- Genieße dein Setup!
Die Nitride-Oberfläche sorgt für eine engere Abdichtung. Daher ist es äußerst wichtig, dein Mündungsgerät korrekt am Lauf zu torquen und mit Rockset zu fixieren.
Produktmerkmale:
- 17-4 PH H900
- Kompatibel mit Atlas und Atlas XL
- Plan B kompatibel
- Atlas XL Adapter ohne Überlauf
- Schwarze Nitride-Oberfläche (67 HRC Oberflächenhärte)
- Shims nicht enthalten – wenn du speziell timen möchtest, sind Shims erforderlich.
Hinweis: Dein Lauf benötigt möglicherweise einen Shim, wenn der Hersteller keinen Gewindefreiraum vorgesehen hat.